1
20.7 Legacy Series / Re: Zerotier controller
« on: September 11, 2020, 05:14:11 pm »
Anyone? Even manually will do, but since OPNSense is embedded I can't be sure the configuration will stick around.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
20.7 Legacy Series / Zerotier controller
« on: August 21, 2020, 01:38:33 am »
Is there any way to setup the zerotier service on opnsense as a controller or both controller/peer?
3
Hardware and Performance / Re: Problems with KVM
« on: August 16, 2019, 06:16:38 am »
Guess I forgot to reply, I was running bare metal with Opensuse.
I've applied every kind of optimization I could then I gave up, I'm using Xen now which runs fine and without chokes.
The Realtek card still kind of doesn't work, I guess the driver is too bad or the card defective.
I've applied every kind of optimization I could then I gave up, I'm using Xen now which runs fine and without chokes.
The Realtek card still kind of doesn't work, I guess the driver is too bad or the card defective.
4
Hardware and Performance / Problems with KVM
« on: August 09, 2019, 03:54:21 am »
I have been running opnsense on KVM for a while and noticed some random drops here and there, then after inspecting, I saw huge CPU spikes, with idle inside the virtual machine usually eating up more than half of the CPU.
I'm kinda at a loss because I couldn't find anything on the internet to help me, most threads on this forum regarding VM issues seem to get no answer at all.
I tried to follow the docs to a T while trying to adapt it to my needs, so I'll try to be more verbose about my config:
So what I could try next? Maybe convert the virtual cards to virtio?
I'm kinda at a loss because I couldn't find anything on the internet to help me, most threads on this forum regarding VM issues seem to get no answer at all.
I tried to follow the docs to a T while trying to adapt it to my needs, so I'll try to be more verbose about my config:
Code: [Select]
Opensuse 15.0, Linux 4.12.14, libvirt 4.0, qemu 2.11.2
1 Core pinned to the last physical core
1280M to the VM with Hugepages enabled
Disk mapped to physical LVM partition, as SATA
3 Virtual NICs pointed to bridges, one of them bridged to the LAN port, all e1000
2 Realtek 8168 cards, one of them is WAN on PCI passtrough
1 Intel card, which goes to another server, also on PCI passtrough
Usual QEMU/Libvirt devices (Serial port, VGA video, Keyb, Mouse, USB2)So what I could try next? Maybe convert the virtual cards to virtio?
Pages: [1]