Messages

@NilsS Thanks for your message. I tried out adding a route manually like you described (Advanced Options in VPN Client configuration) and now my system feels more deterministic again; I could check "Don't pull routes" and "Don't add routes" and it still works. Now I can tweak rules. Thank you!

I was trying to get (Nord)VPN running and route all LAN traffic through it but I can't get it working without pulling routes from the VPN Host, which in turn messes up my routing and all rules get "randomized"... is there any progress on this issue? Would it make sense to downgrade to 17.x?

I was using a WRT54GL while waiting for the card, so yep, that's what I'll stick to for now. FreeBSD is not a good choice for WiFi I suppose (I was aiming for a all-in-one AP, firewall, gateway, vpn box). I wonder if *any* M.2 card would support hostap mode in OPNsense.

Well, the card was seen by the kernel modules I losded (iwm) but:

# ifconfig wlan0 create wlandev iwm0 wlanmode hostap
ifconfig: SIOCIFCREATE2: Operation not supported
# ifconfig wlan0 create wlandev iwm0
# ifconfig wlan0 list caps
drivercaps=580c001<STA,SHSLOT,SHPREAMBLE,WPA1,WPA2,WME>
# ifconfig wlan0 destroy

So no support for hostap and I will return it. No luck under freeBSD.

Thanks! I was ordering a 7265 and it's listed. Fingers crossed.

Is there one (M.2) Network card that would work? Like any model at all?

Hi! I was trying to get a "Intel Corporation Wireless 8265 / 8275 network" card to work with OPNsense (I want to use it as an Access Point), but all I find are patches for FreeBSD 12-something. Are there plans to support this hardware in near future?