"
I'm trying to setup a VPN client, and I'm seeing a strange issue when trying to set the Outbound NAT.
I can't select the WAN as the Translation / target, when I do i receive the error:
The following input errors were detected:
A valid target IP address must be specified.
However if I pick any other network it seems to be OK. Unfortunately I need to configure the NAT for the WAN interface.
Seems to be a similar problem as others in the thread.
I can't select the WAN as the Translation / target, when I do i receive the error:
The following input errors were detected:
A valid target IP address must be specified.
However if I pick any other network it seems to be OK. Unfortunately I need to configure the NAT for the WAN interface.
Seems to be a similar problem as others in the thread.
