Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - andreamenchetti

#1
Hi, I'm sure it's not off topic... APU3 is like APU2 optimized for LTE sim accesses.
So... my APU3A4 (bios 4.0.11), mSATA 16GB:

Opnsense 17.7 (based on freebsd 11), no way to run by usb memstick, sd card, msata (ahci timeout).
Opnsense 17.7.5 (based on freebsd 11), no way to run by usb memstick, sd card, msata (ahci timeout),
update to 17.7.7 was bad too (ahci timeout in 5 minutes from boot time).
The tunable hint.ahci.0.msi=0 is a palliative... 15 minutes instead 5 minutes...

Opnsense 17.1.4 (based on freebsd 10), ok (with plugin os-boot-delay installed), update to 17.1.11_1 was ok too.

Try it yourself and enjoy.
Sorry for my English...  :'(

AM
#2
Aggiornamento.

Ho installato direttamente da iso masterizzata su disco mSATA con adattatore mSATA-SATA,
versione 17.7.5.

Tutto ok finchè non ricevo molti errori di ahci0 timeout.

Inserisco nel file /boot/defaults/loader.conf le seguenti righe:

hint.ahci.0.msi=0
hint.ahci.1.msi=0

fatto upgrade a 17.7.7_1 senza problemi.... solo un po' di lentezza nel reboot...

Ah dimenticavo APU3 bios 4.6.0

PS: PfSense 2.4 su questa motherboard è una spada... direttamente con la versione Memstick

Ciao,
AM
#3
Ciao, no purtroppo. Con la configurazione hardware descritta al primo aggiornamento va in mountroot> e non se ne esce. Stesso problema con 17.7.6 attuale.

Ho provato OPNsense per avere i pacchetti di sicurezza inclusi, ma evidentemente conviene cambiare hardware.

AM
#4
Ciao!
Posto la mia esperienza con OPNsense... spero serva d'aiuto a tutti voi.

Hardware:
apu3b4
msata16g

Software:
OPNsense 17.1.4 - single/dual wan - blocco connettività Internet dopo circa 1h, necessario riavvio
OPNsense 17.7 - ok, ma dopo upgrade 17.7.5 va in mountroot>, dual wan - blocco connettività Internet random

Ho ordinato un adapter mSATA<-->SATA per verificare msata16g (semmai lo rimando in garanzia)

Nel frattempo su USB key e SD stessi identici problemi...

Ho testato il tutto con i seguenti firmware:

apu3_v4.6.1
apu3_v4.6.0
apu3_v4.0.12
apu2_v4.0.11
apu3_v4.0.7.1 (raccomandato da PCengines)

con i medesimi risultati.

Tutto sommato si stava meglio quando si stava peggio (PfSense...)
:) :) :)

Ad maiora!
AM

#5
Italian - Italiano / Re: Benvenuti
October 07, 2017, 02:59:02 PM
Ciao a tutti!

8)