"
Hi, I have fresh install of opnsense and I cannot ping LAN interface from the LAN network. I can open web interface. I've checked logs and there is no entry that the ICMP would be blocked. Do I have to enable it somewhere?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
17.1 Legacy Series / Unable to get Multi Wan working
May 18, 2017, 10:56:54 AM
Hello,
I have a router with one LAN and two WAN ports for failover. Both WANs do have static address, both have monitoring enabled - I have followed the documentation for multiple wan setting. Unfortunately it does not work, the default gateway is not switched to Tier2 WAN when the Tier1 is down even though the "allow default gateway switching" is enabled. I've tried to unset the default gateway on the WAN1 with no effect. Do you anyone know how this should work?
I have a router with one LAN and two WAN ports for failover. Both WANs do have static address, both have monitoring enabled - I have followed the documentation for multiple wan setting. Unfortunately it does not work, the default gateway is not switched to Tier2 WAN when the Tier1 is down even though the "allow default gateway switching" is enabled. I've tried to unset the default gateway on the WAN1 with no effect. Do you anyone know how this should work?
Pages1
