Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - mcmahoc

#1
20.7 Legacy Series / Re: 20.7.4 Success!! PPPoE?
October 28, 2020, 10:44:16 AM
Quote from: bunchofreeds on October 24, 2020, 10:34:23 PM
My setup is really quite stable now with Sensei on the LAN on vtnet thanks to all the great work that has been done.
I'd also like to get Suricata IPS running on the WAN which for me is PPPoE again on vtnet.

Same here, running OPNSense 20.7.2 on ESX 7 using the E1000e NICs. Sensei is great on LAN networks, but really would like Suricata in IPS mode on PPPoE WAN. :)
#2
Hi mb,

Sent a bug report.

Thanks
#3
Hi,

I think I'm missing something fairly fundamental about Captive Portal configuration (apologies for being a bit dim). I have enabled it Captive Portal for one my interfaces that Sensei is monitoring, and I assume it's working because I had to "log in" to get access to the internet from the clients connected to that network zone. I know Sensei is monitoring the interface because I get the sensei block page when visiting a restricted page.

However, Sensei still only shows anonymous egress / ingress.

Captive Portal config screenshot attached.
#4
Hi,

Is there a guide for configuring Captive Portal for use with Sensei? Currently all traffic is dedicated to anonymous users. I don't have the AD / LDAP integration feature on my subscription and it would be great to know who is doing what.

Not sure what other details anyone would need if they are able to assist other than:
OPNSense v20.7.2
Sensei v1.6
Currently monitoring LAN network

One other question: Should I look at adding my WAN interface to Sensei?


Thanks,
Chris
#5
Hi,

Just joined the forum as I found this which helped me get 17.1 up and running and hope this helps others.

If you remove MS update KB3172614 or KB3179574 you can resume a faulting 17.1 upgrade. Once the upgrade completes if you perform another update 17.1.1 will install, after this completes you can reinstall the offending MS updates.

Got this from https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=212721


Thanks,
Chris