Show Posts
1
16.7 Legacy Series / Re: problems with WAN between two virtual Opensense
« on: January 19, 2017, 11:00:45 am »
Peter,
i'm having the same problem and the same test setup as in your picture
Testing between a vigor firewall and an opnsense firewall on the same wan subnet I cannot reach the web interface of the opnsense.
Tracing with wireshark reveals that the traffic from the vigor reaches the opnsense and the opnsense answers to the right L3 ip address (vigor) but in L2 it is sends the frame to the mac adress of my default gateway.
the arp table of the opnsense contains the correct ip/mac combination for my vigor.
For me pfctl -d doesn't help.
Is this by design or a bug?
The same setup with a opnsens replaced with a pfsense firewall works (correct?)
Marnix
i'm having the same problem and the same test setup as in your picture
Testing between a vigor firewall and an opnsense firewall on the same wan subnet I cannot reach the web interface of the opnsense.
Tracing with wireshark reveals that the traffic from the vigor reaches the opnsense and the opnsense answers to the right L3 ip address (vigor) but in L2 it is sends the frame to the mac adress of my default gateway.
the arp table of the opnsense contains the correct ip/mac combination for my vigor.
For me pfctl -d doesn't help.
Is this by design or a bug?
The same setup with a opnsens replaced with a pfsense firewall works (correct?)
Marnix