"
For information, my problem is solved. I handed over an IP for LAN. I have also authorized all in Floating tab at the rules. Also in the rules at the LAN I disabled IPV6. I again removed the IP for LAN and then everything is OK.
Regards
Regards
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
16.7 Legacy Series / [SOLVED] Re: Can't connect to opnsense bridge mode
September 08, 2016, 10:58:42 AM #2
16.7 Legacy Series / Re: Can't connect to opnsense bridge mode
September 08, 2016, 09:45:09 AM
...
When I ping from a machine in the same subnet, I see traces with pftop in console mode? Maybe is it a filtering worries? it seems surprising because I allow all? What do you offer me?
Please help me... :-\
Regards
When I ping from a machine in the same subnet, I see traces with pftop in console mode? Maybe is it a filtering worries? it seems surprising because I allow all? What do you offer me?
Please help me... :-\
Regards
#3
16.7 Legacy Series / [SOLVED] Can't connect to opnsense bridge mode
September 07, 2016, 02:35:28 PM
Hello,
After following the link https://docs.opnsense.org/manual/how-tos/transparent_bridge.html,
it is impossible for me to reconnect opnsense firewall. I have two interfaces, LAN and WAN. I installed the 16.7 release. Must check other things? Can you help me please, thank you.
Regards
After following the link https://docs.opnsense.org/manual/how-tos/transparent_bridge.html,
it is impossible for me to reconnect opnsense firewall. I have two interfaces, LAN and WAN. I installed the 16.7 release. Must check other things? Can you help me please, thank you.
Regards
Pages1
