Show Posts
1
16.1 Legacy Series / LACP interface configuration from console
« on: April 27, 2016, 02:37:24 pm »
I have a couple of machines I want to turn into firewalls with opnsense. They have 4 NICs each, which I have configured on my switch into two LACP groups.
The only way I see to do LACP is to configure it from the web interface, which I can't get into until I setup networking from the console.
Is there a way I can configure LACP before the initial web configuration?
I tried doing it manually from the shell, but the web server still didn't seem to respond. I'm guessing there is an additional configuration for the web server that would need to be done afterwards.
The only way I see to do LACP is to configure it from the web interface, which I can't get into until I setup networking from the console.
Is there a way I can configure LACP before the initial web configuration?
I tried doing it manually from the shell, but the web server still didn't seem to respond. I'm guessing there is an additional configuration for the web server that would need to be done afterwards.