Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - cphase

#1
Hardware and Performance / Re: CF and TRIM
February 18, 2016, 07:01:37 PM
Hi Franco,

     Thanks for the reply and the work around. I will try and get you the exact error message as soon as possible. It is not the one that you posted though.

Quote from: franco on February 18, 2016, 07:03:12 AMhttps://forums.freebsd.org/threads/50436/

Thanks,
Jeff
#2
Hardware and Performance / CF and TRIM
February 18, 2016, 02:13:55 AM
Installed OPNsense 16.1 today onto a 4 gb Kingston cf. Install went fine and rebooted fine. Subsequent reboots halt due to a "TRIM" error. If I boot into single user mode, disable TRIM and reboot it is fine, but TRIM is set to "enabled" again so another reboot and it will halt. Is it possible to set it to disable and have it be persistent? Looking forward to doing some testing.

Hardware:
Supermicro X7SPA-H-D525 board
4 gb of ram
4 gb cf(will change to an SSD if test is good)

Thanks,
Jeff