Topics

Hey all,

Been eyeing up my core router recently and noticed that out of the 4 virtual cores assigned only 1 is actually getting load pushed onto it, the setup is very basic just a small OSPF area and some basic firewall rules, is this behaviour normal when only pushing at max 500mbp/s of traffic? The VM is using VMX interfaces on ESXI 7

(sorry about the image size)


Edit:
Updated title to something that wasn't wrote by 1am me...

Hey guys and gals,

Sorry if I have posted this in the wrong section! I've recently been setting up a small OSPF area over my Zerotier VPN and at first I was using the web interface to configure OSPF but found that it doesn't have the options for manual addresses so I started to configure via vtysh however on rebooting my router (even after a copy run start) the Web UI seems to be overwriting my configuration, so how can I install FRR without it installing the webui components?

Thanks!