1
20.1 Legacy Series / OpnSense 20.1.4 WAN (VLAN PPPoE) problem
« on: April 19, 2020, 02:53:29 pm »
Hi all,
I have question related with WAN side VLAN, PPPoE configuration.
initial configuration ;
ONT ==> ISP supplied router ==> pfSense WAN (em0, dhcp)
This was working at least for 5 years. Now I have a chance to get rid of from ISP provided router.
New configuration ;
ONT ==> pfSense WAN (VLAN em0.157 ==> PPPoE) NOT WORKING
ONT ==> OpnSense WAN (VLAN em0_157 ==> PPPoE) Working Until System Reboots
I have PPPoE username and password and also VLAN ID is 157
Normally this should work but it does not so I switched to OpenSense 20.1 with same VLAN and PPPoE informations and it is working until I reboot OpnSense. I need to re assign WAN to em0 then again WAN to VLAN em0_157 - PPPoE each time OpnSense rebooted to get IP from WAN.
I am trying to find a solution via startup script that assigns WAN interface to em0 than VLAN em0_157 - PPPoE.
Since both pfSense and OpnSense are using freebsd is this a generic freebsd issue? But why OpenSense can make PPPoE connection even it is not flawless but pfSense can not?
I also asked same question to netgate forum if I can succeed to fix this issue I will share results from both forum.
Thanks in advance for your comments.
Have healty days.
I have question related with WAN side VLAN, PPPoE configuration.
initial configuration ;
ONT ==> ISP supplied router ==> pfSense WAN (em0, dhcp)
This was working at least for 5 years. Now I have a chance to get rid of from ISP provided router.
New configuration ;
ONT ==> pfSense WAN (VLAN em0.157 ==> PPPoE) NOT WORKING
ONT ==> OpnSense WAN (VLAN em0_157 ==> PPPoE) Working Until System Reboots
I have PPPoE username and password and also VLAN ID is 157
Normally this should work but it does not so I switched to OpenSense 20.1 with same VLAN and PPPoE informations and it is working until I reboot OpnSense. I need to re assign WAN to em0 then again WAN to VLAN em0_157 - PPPoE each time OpnSense rebooted to get IP from WAN.
I am trying to find a solution via startup script that assigns WAN interface to em0 than VLAN em0_157 - PPPoE.
Since both pfSense and OpnSense are using freebsd is this a generic freebsd issue? But why OpenSense can make PPPoE connection even it is not flawless but pfSense can not?
I also asked same question to netgate forum if I can succeed to fix this issue I will share results from both forum.
Thanks in advance for your comments.
Have healty days.