OPNsense Forum
English Forums => General Discussion => Topic started by: jonm on August 04, 2021, 02:44:17 pm
-
If I run a traceroute from a client on my internal network to any Internet address, the first hop after my Opnsense box is always * * * then I get a normal result i.e. a bunch of addresses inside my ISP then on to the destination.
My question is can I do anything about this? Is it some setting I have 'wrong' in Opnsense or could it be the cable modem that's connected to my ISP that's the issue?
Here's an example:
$ traceroute 8.8.8.8
traceroute to 8.8.8.8 (8.8.8.8), 64 hops max, 52 byte packets
1 router (192.168.2.1) 0.464 ms 0.290 ms 0.343 ms
2 * * *
3 rei-kae-sw1-po-2.gw.imp.ch (157.161.254.165) 10.412 ms 8.961 ms 9.801 ms
4 dornach-sw1-vlan-2163.gw.imp.ch (157.161.250.38) 11.975 ms 10.702 ms 11.669 ms
5 prt-hea-sw1-vlan-2030.gw.imp.ch (157.161.251.21) 10.230 ms 10.364 ms 11.938 ms
6 prt-cbl-sw1-vlan-2003.gw.imp.ch (157.161.251.9) 13.967 ms 14.590 ms 25.963 ms
7 prt-cbl-core2-ve-3020.gw.imp.ch (157.161.254.153) 10.812 ms 11.426 ms 11.980 ms
8 72.14.219.38 (72.14.219.38) 11.828 ms 10.343 ms 11.934 ms
9 74.125.243.161 (74.125.243.161) 12.526 ms
74.125.243.145 (74.125.243.145) 12.765 ms
74.125.243.161 (74.125.243.161) 11.525 ms
10 172.253.50.5 (172.253.50.5) 13.062 ms 15.955 ms
172.253.50.17 (172.253.50.17) 14.812 ms
11 dns.google (8.8.8.8) 10.418 ms 15.114 ms 15.334 ms
-
The next hop is the gateway for your opnsense machine so probably it does not respond to pings. Im assuming that the gw on your opnsense box is your ISP. If its your own equipment then you can enable pinging.