Hi,
I started configuring my OPT1 interface and so far no errors. Setup with hostap and wpa2 etc. done. DHCP also done. Now my clients get IP-addresses but can't reach the WAN interface. Am I forgeting something?
The IP-address of OPT1 is 192.168.2.1 with a range for dhcp of 192.168.2.0/24
my outbound NAT rules are as follows:
WAN 127.0.0.0/8 192.168.1.0/24 192.168.2.0/24 * * 500 WAN address * YES Auto created rule for ISAKMP
WAN 127.0.0.0/8 192.168.1.0/24 192.168.2.0/24 * * * WAN address * NO Auto created rule
I stuck somewhere and it would nice to know where.
Thanks for advice.
Hi,
Have you added any firewall rules for this interface?
If you have, can you share some more information about your setup, like other configured interfaces/ranges and the default route used by this machine?
Cheers,
Ad
Hi Ad,
thank you for your hint to the firewall rules, I totally forgot about the "pass" rules. Added a rule from source Opt1 net to * with pass action.
Now it works like a charm.
Thank you again.
Thanks for your feedback, glad it's solved!