# Interfaces
WAN - XX
LAN - 192.168.1.51/24
LAN 1 - 192.168.65.0/24
LAN 2 - 10.50.53.254/24
# IPSec Phase 2
Local Network: 10.50.53.254/24
Remote Network: 192.168.190.113/32
Hello,
I have an IPSec connection established, however if I try to ping or do curl from the terminal I cannot, only by specifying the IP Address.
I have to do:
curl --interface 10.50.53.254 http://192.168.190.113
If I do without specifying the source address the traffic isn't routed through the IPSec interface (enc0).
Some help is highly appreciated.
I managed to solve my problem by removing the routes that were added:
route del 192.168.190.113
route del 192.168.190.116
Then I did:
route add 192.168.190.113/32 -iface vtnet3
route add 192.168.190.116/32 -iface vtnet3
Is there any way I can do this through the webpanel?