OPNsense Forum

Archive => 17.7 Legacy Series => Topic started by: mitra7 on January 18, 2018, 06:51:45 pm

Title: IPSec LAN-to-LAN Source IP
Post by: mitra7 on January 18, 2018, 06:51:45 pm

# Interfaces
WAN - XX
LAN - 192.168.1.51/24
LAN 1 - 192.168.65.0/24
LAN 2 - 10.50.53.254/24

# IPSec Phase 2
Local Network: 10.50.53.254/24
Remote Network: 192.168.190.113/32

Hello,

I have an IPSec connection established, however if I try to ping or do curl from the terminal I cannot, only by specifying the IP Address.

I have to do:
curl --interface 10.50.53.254 http://192.168.190.113

If I do without specifying the source address the traffic isn't routed through the IPSec interface (enc0).

Some help is highly appreciated.

Title: Re: IPSec LAN-to-LAN Source IP
Post by: mitra7 on January 19, 2018, 03:04:47 pm

I managed to solve my problem by removing the routes that were added:
route del 192.168.190.113
route del 192.168.190.116

Then I did:
route add 192.168.190.113/32 -iface vtnet3
route add 192.168.190.116/32 -iface vtnet3

Is there any way I can do this through the webpanel?