Hi all
I noticed it is needed to also define WAN interface-addresses, if there should be NAT traffic from WAN into DMZ for example. (I didn't know it would affect WAN OUT directions too if I only put the WAN interface, without the WAN-dest-address).
My situation is that I have a WAN pool with 2 GWs.
But when trying to setup NAT for both GW i therefore need to DOUBLE every entry in FW/NAT (each with the intf-address of the corresponding WAN port).
Is there a way to substitute all WAN interface-addresses?
Would "this Firewall" be a safe choice? I'm not sure of this term.
Thank you
Best
Manu