Hi,
my network has 3 addresses.
on re1 172.30.90.0/24
VLAN on re1 172.16.0.1/16 (Guest)
VLAN on re1 10.1.3.1/24 (cam)
When I look in routes->Status.
At first there is automatic a gateway created by opnsense
After a time, a cannot reach from 172.30.90.0/24 the other lans.
when I look at routes->Status, the routes are lost.
I don´t know how? What I´am doing wrong?
At night I start a cron-job "Periodic interface reset".
Actually I have no access to 10.1.3.0 net?!
Greets
Byte
Hi,
can anybody help me?
I don´t know, how to analyze and solve the problem.
Greets
Byte
System: Routes: Status shows your routing table.
And take care to use auto-detection for gateway in interface section.
Hi,
thanks for help.
here are my route status, filtered to default and 10.1.3 and 172.16.0.
ipv4 default XX.XXX.XXX.XXXX UGS 145996 1492 pppoe0 WAN
ipv4 10.1.3.1 link#8 UHS 6 16384 lo0
ipv4 172.16.0.1 link#7 UHS 0 16384 lo0
On Interface-config,
IPv4 Upstream Gateway only can select Auto-detect!
Should I push + to add one custom?
I so, wich values ?
Gateway IPv4 127.0.0.1 ?
and so on ?
Greets
Byte
Hi,
Problem is solved. I delete all VLANs and install again.
Now routes added automatic...
Greets
Byte