OPNsense Forum
Archive => 19.7 Legacy Series => Topic started by: Bytechanger on May 26, 2019, 09:25:45 am
-
Hi,
my network has 3 addresses.
on re1 172.30.90.0/24
VLAN on re1 172.16.0.1/16 (Guest)
VLAN on re1 10.1.3.1/24 (cam)
When I look in routes->Status.
At first there is automatic a gateway created by opnsense
After a time, a cannot reach from 172.30.90.0/24 the other lans.
when I look at routes->Status, the routes are lost.
I don´t know how? What I´am doing wrong?
At night I start a cron-job "Periodic interface reset".
Actually I have no access to 10.1.3.0 net?!
Greets
Byte
-
Hi,
can anybody help me?
I don´t know, how to analyze and solve the problem.
Greets
Byte
-
System: Routes: Status shows your routing table.
And take care to use auto-detection for gateway in interface section.
-
Hi,
thanks for help.
here are my route status, filtered to default and 10.1.3 and 172.16.0.
ipv4 default XX.XXX.XXX.XXXX UGS 145996 1492 pppoe0 WAN
ipv4 10.1.3.1 link#8 UHS 6 16384 lo0
ipv4 172.16.0.1 link#7 UHS 0 16384 lo0
On Interface-config,
IPv4 Upstream Gateway only can select Auto-detect!
Should I push + to add one custom?
I so, wich values ?
Gateway IPv4 127.0.0.1 ?
and so on ?
Greets
Byte
-
Hi,
Problem is solved. I delete all VLANs and install again.
Now routes added automatic...
Greets
Byte