Hello,
i have configured a OpenConnect connection to a ASA. It works fine itself, but there is one issue. I need to NAT the connection.
Without NAT when i do a connect, there is a set of Route added as needed by Openconnect.
When i switch to "Hybrid outbound NAT rule generation (automatically generated rules are applied after manual rules)", then no more roles are not added to the list of Route automaticaly. I did not change anything to the Openconnect configuration, but adding a NAT result in the missing Route.
I do not wan´t to add the Route manualy, as they where change by time without notice to me.
any hind to get the Route add with NAT is a great help.
Thanks
Still hope for some help, if the question is to unclear, please tell me what information is neccessary.
You need to assign the OpenConnect interface, enable lock but leave ipv4 config to none. Then you can add manual rules to OpenConnect.