OPNsense Forum

Archive => 19.1 Legacy Series => Topic started by: Spirit on March 21, 2019, 02:49:48 pm

Title: OpenConnect -> no Route set with NAT
Post by: Spirit on March 21, 2019, 02:49:48 pm

Hello,

i have configured a OpenConnect connection to a ASA. It works fine itself, but there is one issue. I need to NAT the connection.
Without NAT when i do a connect, there is a set of Route added as needed by Openconnect.
When i switch to "Hybrid outbound NAT rule generation (automatically generated rules are applied after manual rules)", then no more roles are not added to the list of Route automaticaly. I did not change anything to the Openconnect configuration, but adding a NAT result in the missing Route.
I do not wan´t to add the Route manualy, as they where change by time without notice to me.

any hind to get the Route add with NAT is a great help.

Thanks

Title: Re: OpenConnect -> no Route set with NAT
Post by: Spirit on April 01, 2019, 11:17:22 am

Still hope for some help, if the question is to unclear, please tell me what information is neccessary.

Title: Re: OpenConnect -> no Route set with NAT
Post by: mimugmail on April 01, 2019, 05:00:22 pm

You need to assign the OpenConnect interface, enable lock but leave ipv4 config to none. Then you can add manual rules to OpenConnect.