Hello to all,
sorry for my bad English, normaly i post the treads in the german forum section.
I have a OPNsense 19.1 and i will use the OpenVPN road warrior. After the configuration my Windows Client is not able to establish a connection. Yesterday i have tried to find the error, but after 4 Hours i have give up. Today with the new Update the error is not the same, but iam not able to establish any Connection. Ist this a Problem from OPNsense 19.1 or ist the Problem my Windows Client or my configuration?
Thank you
Gandalf123
Is your Hostname and Port on the Client Export page correct?
It seams, that you left the internal ip in there, and port 443 is that correct for your setup?
i have tested first the Configuration on my productive System, this is behind a Lancom router, and there was not work.
then i have installed another Opnesnese 19.1 in my Virtual lab for testing, and also i cannot connect me. The Wan IP in my Lab is an internal ip. I have no more ideas with the Problem. I have disabled the block private adresses on the Wan interface, and i have added the rule on the Wan side. Also a allow all on the openvpn interface.
best regards
Gandalf123
There are a few issues with openvpn on in 19.1 . There is an update release 19.1.1 which addresses these and other issues planned for release in the next day or so.
Edit.. it appears it's been released.
i have installed the update today, but the problem persist. The export is now working fine