Text only | Text with Images

OPNsense Forum

Archive => 18.7 Legacy Series => Topic started by: Brent Dacus on December 02, 2018, 07:04:28 PM

Title: Disable Traffic Shaper
Post by: Brent Dacus on December 02, 2018, 07:04:28 PM
All: 

I searched and read lots of posts.  I set up guestnet shaping.  Now I want to remove it / disable.  So I removed all the rules, and pipe.  Applied even reset.  Then rebooted.  The connection is still limited?  What have I missed? 
Title: Re: Disable Traffic Shaper
Post by: mimugmail on December 02, 2018, 07:11:21 PM
Screenshots of Pipes please
Title: Re: Disable Traffic Shaper
Post by: Brent Dacus on December 02, 2018, 07:15:20 PM
all removed
Title: Re: Disable Traffic Shaper
Post by: Brent Dacus on December 02, 2018, 07:29:24 PM
As well the queues and rules. I removed them all. The system reports no limiter on system. However the speed test still shows 50 mbbits.  Even dumped the state tables and reboot the Mac as well.
Title: Re: Disable Traffic Shaper
Post by: mimugmail on December 02, 2018, 09:52:09 PM
And Status says nothing???
Title: Re: Disable Traffic Shaper
Post by: Brent Dacus on December 02, 2018, 11:01:53 PM
Could not find limiters on system..
Title: Re: Disable Traffic Shaper
Post by: mimugmail on December 02, 2018, 11:34:42 PM
What happens when you enable shaping again with 100mbit?
Title: Re: Disable Traffic Shaper
Post by: Brent Dacus on December 03, 2018, 12:42:53 AM
Ok when I can will try that. Strange that removing doesn't work though. Thanks so far.
Title: Re: Disable Traffic Shaper
Post by: mimugmail on December 03, 2018, 06:24:49 AM
I'm sure WiFi or service provider is limiting to 50 or whatever. We'll see when you set to 100 :)
Title: Re: Disable Traffic Shaper
Post by: Brent Dacus on December 06, 2018, 04:10:57 PM
You are absolutely correct. It's not opnsense. It's a bad firmware update by att. The have broken DMZ in the latest firmware. If I take it out of dmz mode works great.   8)
Text only | Text with Images