Home
Help
Search
Login
Register
OPNsense Forum
»
Archive
»
18.7 Legacy Series
»
New Install - APU - No States and other issues
« previous
next »
Print
Pages: [
1
]
Author
Topic: New Install - APU - No States and other issues (Read 2523 times)
sbtech
Newbie
Posts: 7
Karma: 0
New Install - APU - No States and other issues
«
on:
December 12, 2018, 03:25:39 am »
I setup a fresh install on an APU and configured 5 networks, 2 WAN and 3 LAN.
Primary WAN is Fiber and WAN2 is Comcast in DHCP.
2 LANs are public IP blocks assigned to me and the 3rd LAN is a private IP space 10.2.2.0/24.
I have several servers and my WISP router (PFSense) configured and passing traffic thru the opnsense APU over the fiber. private 10.2.2.0/24 is setup to send traffic over the Comcast internet and failover to the fiber. nothing connected to the 10.2.2.0/24 network will pass traffic to the internet, can't ping 8.8.8.8 but can ping public and private router interfaces.
When I goto look at the state table I see nothing (see picture) I feel like some of the other diagnostic tools are missing info too and I also noticed the the outbound NAT was in hybrid mode and the automatic rules are gone.
I have been using PFSense for years and I'm pretty sure I setup thing right but am missing something or my config has broken opnsense.
Logged
sbtech
Newbie
Posts: 7
Karma: 0
Re: New Install - APU - No States and other issues
«
Reply #1 on:
December 12, 2018, 03:52:15 pm »
I started reviewing the config XML and I had tried something that I did not remove after changing subnets for an interface.
I setup one of the LAN interfaces as 10.2.3.0/24 for a minute. After removing this I rebooted the router an the state table is back (and other diagnostic tools). This was also generating an error notification.
<onetoone>
<external>PUBLICIPREMOVED/32</external>
<descr>master.sbtphone.net</descr>
<interface>wan</interface>
<type>nat</type>
<source>
<network>lan</network>
</source>
<destination>
<address>10.2.3.10</address>
</destination>
</onetoone>
Logged
Print
Pages: [
1
]
« previous
next »
OPNsense Forum
»
Archive
»
18.7 Legacy Series
»
New Install - APU - No States and other issues