Can't enable DHCP Server on second interface

[akaylor]

I'm trying to setup a DHCP server on a second LAN interface to segment a lab network.  When I go to Services -> DHCP Server the only interface that shows up, of my 3 active, is LAN, though the UI looks like other interfaces should be shown.  The DHCP Relay is disabled and both Interface settings look to be the same except for their addresses and name. 

Any thoughts as to why I can't add a DHCP server to the second interface?  I'm running 2.3.3-RELEASE-p1 on a Protecli 4 port device.

[bartjsmit]

There is no such OPNsense version. Are you sure you are on the right forum?

Bart...

[franco]

This looks like pfSense, and in all fairness, I think that normally the other interfaces don't show up there because their IP address was set to something other than static addressing. You need to assign a static IP. Same with OPNsense.


Cheers,
Franco

[akaylor]

Whops!  Yeah, wrong forum.  I run OpnSense in my home lab and came here by default. (:

[franco]

Hehe 8)