Enabling VLAN on 10G card causes reboot

[cwesterfield]

I have a Supermicro box (OPNsense 21.1.8_1) with an HP branded 10G card.
I used the boot flag if_oce_load="YES" to get the box to see the two interfaces.

When there are no VLANS running through the 10G, it works great. If I add one, it starts a reboot cycle.

Does that mean the card is incapable of vlans, has bad firmware, or maybe some other thing I don't know about?


Output of pciconf -lveV
oce0@pci0:4:0:0:        class=0x020000 card=0x1747103c chip=0x070019a2 rev=0x02 hdr=0x00
    vendor     = 'Emulex Corporation'
    device     = 'OneConnect OCe10100/OCe10102 Series 10 GbE'
    class      = network
    subclass   = ethernet
  PCI-e errors = Correctable Error Detected
                 Unsupported Request Detected
     Corrected = Advisory Non-Fatal Error
oce1@pci0:4:0:1:        class=0x020000 card=0x1747103c chip=0x070019a2 rev=0x02 hdr=0x00
    vendor     = 'Emulex Corporation'
    device     = 'OneConnect OCe10100/OCe10102 Series 10 GbE'
    class      = network
    subclass   = ethernet
  PCI-e errors = Correctable Error Detected
                 Unsupported Request Detected
     Corrected = Advisory Non-Fatal Error

$ sysctl -a | grep oce | grep ion
net.inet.ip.process_options: 1
dev.oce.1.firmware_version: 4.9.416.2
dev.oce.1.component_revision: ///11.0.50.0///
dev.oce.1.%location: slot=0 function=1 dbsf=pci0:4:0:1
dev.oce.1.%desc: Emulex CNA NIC function:///11.0.50.0///
dev.oce.0.firmware_version: 4.9.416.2
dev.oce.0.component_revision: ///11.0.50.0///
dev.oce.0.%location: slot=0 function=0 dbsf=pci0:4:0:0
dev.oce.0.%desc: Emulex CNA NIC function:///11.0.50.0///

[dinguz]

I don't have any experience with this particular card, but have you tried changing the hardware offloading settings? They are in Interfaces -> Settings. Hardware offloading is known to generate erratic behavior in cards with mediocre drivers. Not this saying this the case here, but it wouldn't hurt to try out.