Archive > 16.7 Legacy Series
Dual WAN + Traffic Shaping
snakeaj:
Hello!
I wan to use Dual WAN (DSL + 4G) and limit bandtwith for each user to 4 Mbit down and 1 Mbit up.
My Problem: in traffic Shaping i can only use an INTERFACE (wan1 or wan2) and not my WAN GROUP.
one more thing i noticed: i can not find "Sticky Connection" which i want to set (Multi WAN howto)
thx
alexander
OPNsense 16.7.11_1-amd64
FreeBSD 10.3-RELEASE-p14
OpenSSL 1.0.2j 26 Sep 2016
rackg:
Hello Alexander,
I still have the issue. You can check this out https://forum.opnsense.org/index.php?topic=3856.msg13582#msg13582. My issue was same on similar setup.
HFsi:
It seems that the issue will see another christmas...I´m stuck with the same problem...
mimugmail:
I haven't tested it yet but I'd create two pipes, each for 1 WAN, 2 queues for each WAN pointing to their pipes and then create rules pointing to the queues in advanced mode with both interfaces (IN+OUT)
franco:
--- Quote from: HFsi on September 19, 2017, 11:55:17 pm ---It seems that the issue will see another christmas...I´m stuck with the same problem...
--- End quote ---
It is unclear what the "same" issue could be. There is a lot of time between Christmas 2016 and 2017. ;)
Cheers,
Franco
Navigation
[0] Message Index
[#] Next page
Go to full version