Archive > 22.7 Legacy Series
Setup 2 Wireguard site2site tunnels - kernel panic
mcouture:
I setup 2 Wireguard site to site tunnels yesterday and everything works as advertised. I can see both sides of each tunnel. So far so good right?
Within a couple hours, OpnSense would kernel panic and reboot. Then within an hour panic again....then again....then again.
I'm running OpnSense in a VM under ProxMox, using KVM64 as the device. My hardware is a TopCon 6port all-in-one device. I have 3 more of these devices all running OpnSense under ProxMox without issue.
I was thinking of trying the KMOD version of Wireguard but unsure....thoughts?
mcouture:
...also, since I got these kernel panics, I finally decided to disable Wireguard in the GUI.
After disabling Wireguard, the system has been stable...
franco:
kmod issue? Or not installed?
mcouture:
KMOD is NOT installed.
franco:
Then same with kmod? Got a kernel stack trace? Tried disabling shared forwarding?
Cheers,
Franco
Navigation
[0] Message Index
[#] Next page
Go to full version