English Forums > Zenarmor (Sensei)
Zenarmor & IPv6: Bad Combo (At least on ATT Fiber/US)
athurdent:
--- Quote from: lrosenman on January 10, 2022, 04:49:05 pm ---NOTHING.
--- End quote ---
Good luck getting further help with that yelling attitude.
lrosenman:
--- Quote from: athurdent on January 10, 2022, 05:25:42 pm ---
--- Quote from: lrosenman on January 10, 2022, 04:49:05 pm ---NOTHING.
--- End quote ---
Good luck getting further help with that yelling attitude.
--- End quote ---
softened the wording.
sy:
Hi,
Looking into via ticket. I will also update here.
sy:
Hi,
The reason for the loss of connectivity is that when Zenarmor packet engine opens the interface in the netmap mode, netmap re-initializes that interface, causing a DOWN/UP link event.
Seeing an interface DOWN/UP event, OPNsense fires IPv4/IPv6 address re-configuration. For IPv4, this takes milliseconds, bur for IPv6, due to auto-configuration, WAN tracking etc, this process might take about 15-60 seconds during which time you might lose WAN connectivity.
After this, everything should be back to normal.
We’re aware of this issue, however the solution involves working with 3rd parties (netmap team, OPNsense team etc).
For the final solution, several options are on the table and we’re working on them.
I hope this helps clarify the situation
lrosenman:
As I said in my ticket reply, even after the connectivity is fixed, IPv6 packets don't make it past OPNSense with the packet engine running.
What else can I provide?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version