English Forums > Tutorials and FAQs
SNMP
Rob2500:
I haven't seen any posts regarding this topic. So maybe everything is clear to everyone except me.. ;-)
Here are my questions:
Does SNMPv3 require to configure Listen IPs, or is this only for SNMPv1?
Then I don't see where I can add trap destinations. Is this possible somehow?
Cheers,
Rob
mimugmail:
Traps are currently not supported, you can add a Feature request via GitHub Plugins repo
baqwas:
Hello @mimugmail,
I tried the following command (to initiate a collection of MIBs that I could use subsequently for Nagios NRPE work):
$ snmpwalk -v1 -c public 192.168.1.1 1.3.6.1.2.1.1.6.0
and the response was:
Timeout: No Response from 192.168.1.1
I have enabled SNMP through OPNsense for the box. What else do I need to do to collect some sample data for further tests?
Thanks.
mimugmail:
Allowed Port 161/udp on Firewall? Community is correct?
baqwas:
Hello @mimugmail,
Firewall rule is LAN <-> LAN wildcard for any port number. Double checked the community string too - it is correct. The Listen IP address is the one where the command is being typed. FWIW, the equivalent command in the same LAN gets me a boatload of data from a NetGear ProSafe switch with the top few (name, uptime and some traffic counts) are the MIBs of interest for a common dashboard view of the farm. Thanks.
Kind regards.
Navigation
[0] Message Index
[#] Next page
Go to full version