Nat not working

[jesperfr]

Hi all,

I have an issue.

Firewall is running 19.1.4

On my firewall I have 3 interfaces:
VLAN10 (10.220.0.0/16) interface address 10.220.0.9
VLAN32 (10.222.0.0/16) interface address 10.222.8.4
WAN

I have a source address (10.220.2.75) comming from VLAN10, and I need it to be translated to an address on VLAN32 (10.222.10.251 or VLAN32 interface address) and run it throuh an IPSEC tunnel.

I can't get this to work. I have tryed to do both one-to-one and outbound nat.


In picture attached is:
- KACE (10.220.2.75)
- Salling_group (IP address that should be reached through IPSEC tunnel. I have also tryed to have WAN address, but still the same)
- VLAN_32_NAT_INTERFACE (VLAN32 interface address as an alias)


Any surggestions ?

Thanks in advance

Rgds,
Jesper

[jesperfr]

Have anyone had the same problem and have found a solution???