IGMPv3 (SSM)

[skywalker007]

config here:
/usr/local/etc/igmpproxy.conf
could you post the content please?

make sure it's not running:
killall igmpproxy
run interactively with verbose output:
/usr/local/sbin/igmpproxy -n -vv /usr/local/etc/igmpproxy.conf

[DoomSalamander]

Alright took me a while to figure it out to get the file. Did it with filezilla. Here you go:


##------------------------------------------------------
## Enable Quickleave mode (Sends Leave instantly)
##------------------------------------------------------
quickleave
phyint pppoe0 upstream ratelimit 0 threshold 1
altnet 239.35.0.0/8
altnet 224.0.0.0/4
altnet 193.158.0.0/15
altnet 232.0.0.0/8
altnet 87.128.0.0/15
altnet 87.141.0.0/15
altnet 239.32.0.0/16

phyint pppoe0 downstream ratelimit 0 threshold 1
altnet 192.168.2.1/24

phyint igb1 disabled
phyint igb0 disabled

[skywalker007]

looks like you have pppoe0 configured as downstream as well as upstream. That's weired.
You would need to configure a LAN interface as downstream.

[DoomSalamander]

Seems to work now. The weird thing is also that it once switched booth up and down to "IPTV". I didn't know that downstream had to be on a LAN though. I always assumed it had to be WAN too. Now that I re-read that blog I feel stupid. It also says choose LAN device. Well never mind. Thanks for helping it works now! So here we have it Entertain 2.0 works with opnsense! I did it like your settings.

[DoomSalamander]

OK I still got one small problem. If I restart the receiver it now says that the rtp server isn't answering.

Don't know what exactly went wrong. I resettet opnsense and redid everything from scratch. Works like a charm again.

[k0ns0l3]

I also tried skywalker007's setup and it doesn't work. While I do get an image it will stutter after a few seconds. I have the 401 receiver connected directly to opnsense. The same result happends if I connect the 401 with a igmpv3 ready zyxel switch. The switch works fine if I use my draytek as a normal router and use it's built in igmp.

My setup is draytek 165 -> opnsense pppoe login with vlan7 -> 401 receiver

the same thing to me 

[DoomSalamander]

Well don't know about you but I made a stupid mistake and used WAN in the down link of the IGMP proxy instead of LAN. After I fixed that his rules setup works perfectly.

[MAGIC]

Hello Skywalker. Your link does not work ;-)

This one should:
https://cloud.sector42.eu/f/32dfda4989134974a637/

Hey this links is not working anymore.

Anyway I have a MR401 too since I moved and there's no other way to get TV. My conf is currently a Fritzbox with Exposed Host to my OPNSense on a pcengine APU and the MR401 is connecting via LAN to the APU. working firewall rules are prob on this picture.