Stucking at "Boot: F1" after installation

[moocan]

Hello,

Four times I tried to install OPNsense 19.1 on an appliance.
I tried guided installation and advanced installation over two different devices.
After installation then reboot and ...
I'm stucking at

Code: [Select]

F1  FreeBSD                                                                     
                                                                               
F6 PXE                                                                         
Boot:  F1                                                                       
\   
nothing more ... no activity on device led.

Installation media "OPNsense-19.1-OpenSSL-serial-i386.img" is starting successfully without any trouble on the same devices.
Kernel is loading, serial access is OK, all network interfaces are discovered and I can access the web interface on the live media.

How can I install it and have a working installation ?

Kind Regards

[marjohn56]

log in using the 'installer' rather than 'root'.