English Forums > Documentation and Translation
[Bridge Mode] OpenVPN, DNS ?
zyon:
Hi all,
I have search but found nothing about bridge mode and OpenVPN...
Try all i have could be found but nothing help me, because always says open on AT but on bridge i have disabled my NAT.
OpenVPN work well (internet and connect to OPNsense) with my users.
Same question from a lot of poeple is my LAN(OPT1) access, sorry again to ask ...
All in "pass" but nothing.
Try a lot of time and used this : https://docs.opnsense.org/manual/how-tos/sslvpn_client.html
https://ibb.co/PZq7gZt
Same Tunnel Network 10.10.0.0/24 , my OPT1 Network 10.0.0.0/24
Add ACL to DNS, Push route to OpenVPN but nothing :s ...
If someone can help me ...
Thanks
(Sorry for my English)
bartjsmit:
You need to have OpenVPN in 'dev tap' mode to bridge with ethernet since a bridge is a layer 2 device.
Bart...
zyon:
Thanks Bart ... not think to try that .... :-X
Sorry ^^
(Sorry for My English)
zyon:
On Mobile connection get : TAP_NOT_SUPPORTED OSI layer 2 tunnels are not currently supported :s
And same on PC no lan :s... i don't understand
bartjsmit:
I'm afraid that is a known shortcoming of mobile platforms. It is fairly easy to run a TAP client on (x86) Linux though.
Which protocol do you require that needs a layer 2 connection? It is more efficient to run OpenVPN with 'dev tun' and it causes fewer issues, as you have found out.
Bart...
Navigation
[0] Message Index
[#] Next page
Go to full version