16
18.1 Legacy Series / Re: OpenVPN Broken
« on: February 01, 2018, 09:23:11 am »
I just tested it on my setup also upgraded for 17.7.12 to 18.1 and I can not confirm or reproduce the issue.
In general I would check the following:
1) Packet capture on OpenVPN and WAN and see if the packets are visible on both. If you see them on both OpenVPN and WAN interface, then make sure the IP on WAN is correctly NAT-ted.
2) If packets flow but some website are not reachable, then make sure if isn't an MRU issue.
Add the following to the advanced section of your configuration:
Hope this helps if not try to make a complete assessment of what is different between 17.7 and 18.1 including config files and make sure NAT/MTU is not the issue.
Cheers,
Jos
In general I would check the following:
1) Packet capture on OpenVPN and WAN and see if the packets are visible on both. If you see them on both OpenVPN and WAN interface, then make sure the IP on WAN is correctly NAT-ted.
2) If packets flow but some website are not reachable, then make sure if isn't an MRU issue.
Add the following to the advanced section of your configuration:
Code: [Select]
mssfix 1200
Hope this helps if not try to make a complete assessment of what is different between 17.7 and 18.1 including config files and make sure NAT/MTU is not the issue.
Cheers,
Jos