31
General Discussion / Re: DNS over TLS Setup help
« on: December 09, 2022, 02:53:28 pm »It needs to go in the DNS over TLS dedicated section in Unbound.
Beat me to it!
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
It needs to go in the DNS over TLS dedicated section in Unbound.
Hi,
I have disabled the service Unbound DNS and re-run the command.
Sorry nothing is changed, the same error:
[1670531369] unbound-checkconf[64742:0] error: duplicate forward zone . ignored.
no errors in /var/unbound/unbound.conf
Hi,
the service is running, this is the result of command:
root@OPNsense:~ # configctl unbound check
[1670530498] unbound-checkconf[36560:0] error: duplicate forward zone . ignored.
no errors in /var/unbound/unbound.conf
root@OPNsense:~ #
Thanks
Yes I do. Static IP's, DHCPv4 server and RA for IPv6 that does tracking on my PPPoE Interface. (fun fact, when I loose the vlan's, I also loose IPv6 everywhere. So I suspect there might be some link somewhere)
That doesn't sort the problem though. My Vlan client's can still ping each other through all the switches and the native vlan continues to work. But I completely loose all the vlan interfaces on the opnsense after a few minutes where it was working. The only log I get is the one I did put on the first post...
I did try with a custom trunk profile. And that's when I got the problem's
Hello,
I'm on 22.7.6 on a protectli. I had a native interface and added vlan's over it with DHCP. I am tagging with a Unifi switch on my "LAN" Port.
It didn't work so I rebooted. After a reboot, it works for something like 10 minutes (DHCP works well on every vlan), firewall to. Then, for seamingly no reason at all, it stops working. No DHCP and not possible to ping the gateway even if I set my IP's manually in the vlan's (native interface still works). After that happen's, I get a small cut in all interfaces and PPPoE's are restarting.
I get this in the log's. No idea from where it comes. Any idea on where to start searching or what I could give to help to track the problem down?