Messages

1

24.7 Production Series / Re: Upgrading 24.1.10 to 24.7: kernel panic and reset (SYS-E300-9A-4C test setup)

« on: November 22, 2024, 03:56:27 pm »

# opnsense-update -ukr 24.7.8 -a FreeBSD:14:amd64 -A 24.7
# opnsense-update -ubp -A 24.1

so the first command worked much better, i saw it download the 24.7.8 packages this time.

i then ran the 2nd command without rebooting in between

after the 2nd command completed i then rebooted properly from the console menu.

------------

after the reboot it was showing booted into 24.7 not 24.7.8 on the main console screen.

is it normal that it is running 24.7.8 kernel, but still showing 24.7 until i do another round of updates ?

2

24.7 Production Series / Re: Upgrading 24.1.10 to 24.7: kernel panic and reset (SYS-E300-9A-4C test setup)

« on: November 22, 2024, 02:18:10 pm »

opnsense-update -ukr -a FreeBSD:14:amd64 -A 24.7

when i run that command, the shell reports "usage: man opnsense-update"

this command did run:

opnsense-update -ubp -A 24.1

but when i reboot it stays on 24.1.10_8

--------------

is there something i am missing?

3

24.7 Production Series / Re: Upgrading 24.1.10 to 24.7: kernel panic and reset (SYS-E300-9A-4C test setup)

« on: November 21, 2024, 05:12:40 pm »

this is my first time posting so my apologies if im not doing this correctly.

is there a way to jump directly from 24.1.10 to 24.7.8 during to the update/upgrade process ( like specify it to skip over 24.7.1 and install 24.7.8 )?

as i cannot do the update normally since the 24.7.1 that gets installed first kernel panics during initialization and then boot loops due to my system having a chelsio card installed.

sadly i cannot pull out the chelsio card as the system is remote.