Show Posts
1
23.7 Legacy Series / Webgui on WAN
« on: November 20, 2023, 11:36:17 pm »
Hello,
I made a fresh opnsense installation from an ISO.
After the webgui wizzard part is finished, I wanted to access the opnsense webgui also via the WAN.
Therefore I apply a FW rule on the WAN Zone to allow tcp 443.
Then I extend the FW rule for an Any Any, that way I was able to ping the WAN interface, but not webgui.
Under System->Settings->Administration is "Listen interfaces set to 'ALL'
When I check "Enable Secure Shell", I'm able to access ssh via the WAN interface. But still no webgui
I tried to use "pfctl -d" without success.
Can you help me, what im missing?
Cheers
I made a fresh opnsense installation from an ISO.
After the webgui wizzard part is finished, I wanted to access the opnsense webgui also via the WAN.
Therefore I apply a FW rule on the WAN Zone to allow tcp 443.
Then I extend the FW rule for an Any Any, that way I was able to ping the WAN interface, but not webgui.
Under System->Settings->Administration is "Listen interfaces set to 'ALL'
When I check "Enable Secure Shell", I'm able to access ssh via the WAN interface. But still no webgui
I tried to use "pfctl -d" without success.
Can you help me, what im missing?
Cheers