"
I am in the same situation as you guys, running the software on a bare-metal HPE server, the speed is limited to 1Gbps. However, when I run opnsense on VMware, I achieve a much better speed of 9.1Gbps.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
#46
23.7 Legacy Series / Re: OPNSense on Proxmox, 10Gb network awful throughput
November 02, 2023, 10:29:37 PM #47
Hardware and Performance / 10Gb speed slow
October 31, 2023, 12:48:52 AM
Hey Opnsense community,
I've been running Opnsense on an HPE Gen 10 server, and I'm experiencing slower than expected network speeds. The server is equipped with an Intel x5220 DA 10GB RJ45 network card, but my speed test results are not reaching the full 10GB speed.
I'd like to optimize my network setup to get the most out of this hardware configuration. Any suggestions or advice on how to troubleshoot and improve the network speed with Opnsense and this Intel network card would be greatly appreciated. Thanks!
I've been running Opnsense on an HPE Gen 10 server, and I'm experiencing slower than expected network speeds. The server is equipped with an Intel x5220 DA 10GB RJ45 network card, but my speed test results are not reaching the full 10GB speed.
I'd like to optimize my network setup to get the most out of this hardware configuration. Any suggestions or advice on how to troubleshoot and improve the network speed with Opnsense and this Intel network card would be greatly appreciated. Thanks!
