Show Posts
1
23.7 Legacy Series / WAN Does not recover if I power cycle my ISP device.
« on: December 18, 2023, 04:04:59 pm »
I noticed this after a recent power failure and might be a new behaviour as I have had power failures before.
If I power cycle my ISP device opnsense will show the WAN as up but no internet services work..
If I then pull the cable and put it back in causing a hard down / up open sense recovers and starts routing again.
I think the interface on the fibre converter comes up before the service is ready and maybe opnsense is failing initially and not re-trying?
This one is tricky as I have to test it outside of the hours the connection is in use.
If I power cycle my ISP device opnsense will show the WAN as up but no internet services work..
If I then pull the cable and put it back in causing a hard down / up open sense recovers and starts routing again.
I think the interface on the fibre converter comes up before the service is ready and maybe opnsense is failing initially and not re-trying?
This one is tricky as I have to test it outside of the hours the connection is in use.