Show Posts
16
22.7 Legacy Series / Setup 2 Wireguard site2site tunnels - kernel panic
« on: January 23, 2023, 01:02:59 pm »
I setup 2 Wireguard site to site tunnels yesterday and everything works as advertised. I can see both sides of each tunnel. So far so good right?
Within a couple hours, OpnSense would kernel panic and reboot. Then within an hour panic again....then again....then again.
I'm running OpnSense in a VM under ProxMox, using KVM64 as the device. My hardware is a TopCon 6port all-in-one device. I have 3 more of these devices all running OpnSense under ProxMox without issue.
I was thinking of trying the KMOD version of Wireguard but unsure....thoughts?
Within a couple hours, OpnSense would kernel panic and reboot. Then within an hour panic again....then again....then again.
I'm running OpnSense in a VM under ProxMox, using KVM64 as the device. My hardware is a TopCon 6port all-in-one device. I have 3 more of these devices all running OpnSense under ProxMox without issue.
I was thinking of trying the KMOD version of Wireguard but unsure....thoughts?