Messages

From the Plusnet community they advice
The Openreach ONT can be seen as a modem, OPNsense is a router NO VLAN is required the ONT looks after that!

HI

Sorry not used to the formatting on this site but that you for pointing it out

Problem 1 i have removed the entry from the DHCP Static Mappings for this interface. But for some reason it has also removed it from the Leases page?

Problem 2  i have the correct details as it is same provider same account same static ip and my details are correctly entered as my old account uses them and if i go back to old connection it works with my ISP.

OK soon as i connect my Zimaboard which runs Opnsense to the new Full Fibre Box i lose connection instantly.

But if i add it back to old connections it works instantly. 

But the FUll Fibre is working correctly according to Opnreasch Engineer as all 3 green lights are on.

He says its my Opnsense modem !!!

Plusnet and my PPPoE is already configured as i am just upgrading speed same user and same I.P address
VLAN not used

Also here are some logs here https://paste.centos.org/view/1ab01a67

ALso here is a image https://xbackbone.osopolar.cloud/ZubU1/ZEheYObi04.png

HI Guys
Not sure if its my hardware or some settings i need to adjust to get my new Full Fibre Connection to work.
Been using Opnsesne for 24 months plus no issue. I have running on a Zimaboard

CPU: Intel Celeron N3450 at 1.10 GHz (Quad-core).
RAM: 8 GB (8380 MB).


Just had it fitted today after 3 months. After fitting it worked i was getting 356 download on Wifi 256 Upload engineer said it would settle down and speed increase.

But it was opposite i lost Wifi then lost  WLAN / LAN i have tried rebooting all the systems but nothing. I have had to add back the old connection and now it works fine.

My setup is described above is there anyway to see what the point of failure is?

My Opnsense modem did not look overloaded and i do not think it would just break the connection?
From Opnsense cable to switch from switch up-to Nighthawk Wifi Router?

Are there any logs i can check to see if its Opnsense or Hardware issues ?

Fixed it all solved now cheers guys

Please could you help further i have turned it on and off a few times it will not start manually 

Hello fully updated I see I issue on Dashboard AdguardHome will not start.
Do i need to turn it off and wait for an update ?

HI
I found your solution cheers for help all good now

Trying to update getting error not sure what it means

Is it refusing to update or do i need to restore  ?

HI
Sorry i dont understand that please see image does that suggest i am on ZFS

Sorry for noob question how can i tell if i am on ZFS

HI Guys
Currently on:-
OPNsense 23.7.12_5-amd64
FreeBSD 13.2-RELEASE-p7
OpenSSL 1.1.1w

Is it safe to update directly to  24.1 ?

I know how to backup but a noob with Opnsesne  :)

Hi Guys
I always take the stand and wait when new update popup to let let more knowledgeable  users test it out.
I am currently set on this

Are there any known issues i need to be wary of or should i hold back a little longer ?


Thorrrr