Messages

Thank you.

I have applied the patch to one of my nodes and I was going to compare the data once I see the alert come through. Right now they look the same except for one item (which I expect because I have one interface configured as a pass through but can only do that on a single unit at a time).

Thank you, I will dig through that post shortly.

RE: Sending the routing table is that just the Status under Routes in the GUI or something else?

This looks related. 2022-02-10T08:47:34-08:00   Warning   miniupnpd   SSDP packet sender 192.168.10.104:60820 (if_index=5) not from a LAN, ignoring

But that is from a LAN so how do I tell the system that?

Did those logs help? Any thoughts here?

Sure, here you go.

When I have gateway monitoring on, i get random alerts that an interface is down. However, it is not actually down (from what I can tell). What can I investigate to get to the bottom of this?

Those are the same steps I followed.

Had the same problem and had to disable gateway monitoring.

We have 3 Xboxes on a dedicated vlan and setup upnp. After setup, everything was rebooted. It was not working and I gave up on the setup. Then after months, I received an alert that one of the devices setup a upnp port. That was last night. Any pointers here as I'm unsure what to do next?

Gotcha. Good to know. Ill block on the Access point then.

I have several VLANs that are set to deny unknown clients but I am able to connect with clients that are supposed to be available on other VLANs only. Running 21.7.7. Known issue?

Looks like this is by design.

I removed the connections and readded and configured and its working correctly now.

Has anyone gotten AdGuard to also listed on virtual IP addresses?

As I am viewing the firewall logs, almost all of the traffic shows that it originates from the WAN interface as opposed to the actual internal interface that it originates from. I think this is causing me other problems (multi-wan doesnt work, cant use UPNP, etc). Did I do something funky that would have caused this? None of my firewall rules seem to be used either as they all default to the "let out anything" rule.

Thanks

Any recommendations on how to troubleshoot this issue?