Messages

46

Zenarmor (Sensei) / Re: problems with whitelisting

« on: August 21, 2023, 11:48:35 am »

Hi,

Could you share all log and config files with the Zenarmor team by clicking on the Send Feedback link at the left bottom of the window?
https://www.zenarmor.com/docs/support/reporting-bug#as-of-v114

Bests

47

Zenarmor (Sensei) / Re: DNS Enrichment Configuration question

« on: August 18, 2023, 08:27:33 am »

Hi,

DNS Server IP address configuration in the DNS Enrichment page is mainly used for querying reverse host records for local IP addresses. Therefore, your OPNsense unbound server may be the perfect choice for you.

Bests

48

Zenarmor (Sensei) / Re: Zenarmor will not register to Cloud Console

« on: August 17, 2023, 08:15:49 pm »

Hi NopSled,

Your issue is fixed in 1.14.3 shipped today. You may try updating Zenarmor.

Bests

49

Zenarmor (Sensei) / Best Practices for Upgrading Zenarmor to v1.14

« on: August 04, 2023, 04:44:05 pm »

Dear valued Zenarmor users,

Even though it has been rigorously tested by the Zenarmor team and upgrading to Zenarmor is a simple procedure that allows you to upgrade your system without incident, it is best to be prepared for Murphy. It is crucial to proceed with caution to avoid disruptions and data loss.

In this post, we will give you a hand in upgrading your Zenarmor NGFW smoothly. If you follow the advice below, the process can be relatively straightforward and have minimal impact on your business.

https://www.zenarmor.com/blog#best-practices-for-upgrading-zenarmor-to-v1.14

Have a good read...
Zenarmor Team

50

Zenarmor (Sensei) / Re: amazon SES smtp for zenarmor reporting

« on: July 19, 2023, 03:34:14 pm »

Hi Obel,

Could you send a bug report to the Zenarmor team by selecting all logs and config files?

https://www.zenarmor.com/docs/support/reporting-bug#sending-feedback-via-opnsense-ui

Best Regards
Bekir

51

Zenarmor (Sensei) / Re: Zenarmor throughput with N5101 / i226v

« on: July 05, 2023, 05:55:26 pm »

Hi athurdent,
Most probably you will get 1Gbps throughput. Because the single thread rating value (1517) of your CPU is approximately the same as the value(1499) of recommended CPU at https://www.zenarmor.com/docs/opnsense/introduction/hardware-requirements.

https://www.cpubenchmark.net/cpu.php?cpu=Intel+Core+i5-5200U+%40+2.20GHz&id=2440
https://www.cpubenchmark.net/cpu.php?cpu=Intel+Celeron+N5105+%40+2.00GHz&id=4412 (Your CPU)

Beware that depending on the load on your CPU, you may get lower throughput.
Best

52

Zenarmor (Sensei) / Re: OPNsense upgrade failure with Zenarmor (23.1.7)

« on: June 14, 2023, 03:11:06 pm »

Hi Almodovaris,

Could you share the kernel panic message and the zenarmor* files under /tmp/ folder with the Zenarmor team?

Bests

53

Zenarmor (Sensei) / We are thrilled to announce our official rebranding to Zenarmor!

« on: June 08, 2023, 08:38:25 am »

Dear valued Zenarmor user,

You're not unfamiliar with Zenarmor. Until now, when searching for us, you mostly used the term 'Zenarmor' in search engines. We have rebranded our corporate company name, Sunny Valley Networks, to Zenarmor. After the domain name change, you will be able to access all the services we previously provided on sunnyvalley.io through zenarmor.com.

Join us on this transformative journey as we continue to innovate, protect, and empower. Visit our revamped website at https://www.zenarmor.com/ to explore our enhanced range of services.

But don't just take our word for it! Our CEO, Murat Balaban, shares his insights and the reasons behind this transformative decision in our latest Zenarmor YouTube video: https://www.youtube.com/watch?v=XH6ETsC4oDI. 🎥

Stay tuned for exciting developments!

54

Zenarmor (Sensei) / Re: i226 + ZenArmor no VLANs

« on: May 25, 2023, 01:12:33 pm »

Hi,

Zenarmor has been doing with OPNsense and Klara on the FreeBSD kernel side which brings bridge device support and a considerable improvement to the emulated mode where several packet stalls and mbuf leaks have been identified and subsequently fixed.

As you might have noticed, OPNsense’s 23.1.6 release has delivered some important kernel updates to the netmap subsystem. Some of them are as follows:

- Improving the reliability and stability of the emulated mode for all ethernet devices
- Add emulated mode support for bridge(4), VLAN(4), lagg(4) and tun(4) pseudo interfaces

You may run Zenarmor with emulated netmap driver on igc device.

Kinds

55

Zenarmor (Sensei) / Re: Introducing Zenarmor 1.13:

« on: May 13, 2023, 04:04:40 pm »

Hi tomkolp,

Could you create a ticket by sending a bug report, please?

https://www.zenarmor.com/docs/support/reporting-bug

56

Zenarmor (Sensei) / Re: Could not verify your mail configuration

« on: May 13, 2023, 04:02:16 pm »

Hi @serbans, @SamBox83,
There is currently a bug in the connection test stage of Zenarmor's scheduled report feature.
However, This issue only affects the testing phase and does not prevent you from using the scheduled reports feature. The bug has been identified and will be fixed in the upcoming 1.13.2 release.

We apologize for any inconvenience this may have caused and thank you for your patience and understanding. We are committed to providing you with the best possible experience and appreciate your support.
Please don't hesitate to contact us Zenarmor team if you have any further questions or concerns.

57

Zenarmor (Sensei) / Re: Subscription revoked after last update? (Maybe PSA)

« on: May 05, 2023, 06:21:10 pm »

Hello,

Below is an important notice about an issue with our license manager associated with the recent 1.13 release.

There was an issue with Zenarmor’s license checking process in release 1.13, which caused a small number of licenses to be erroneously downgraded to the Free Edition.

You may be one of a small group of customers affected by the issue.

We apologize for the inconvenience for the service disruption you might have experienced.

Please check to see if you have been downgraded to the Free Edition. If so, to correct this issue, simply re-activate your subscription with your activation key. All your policies and policy configuration are intact and will be restored once you reactivate your subscription.

Please use the following instructions:

• You can enter your key using the “Upgrade to a Subscription” link in the upper right corner of Zenarmor GUI.
• Or check your subscription status via Zenconsole by visiting the Settings - Subscriptions menu.

If you have experienced this problem and can’t locate your license key, or are unable to resolve this issue, please contact support@sunnyvalley.io. One of our colleagues will be happy to assist you get this taken care of quickly.

Once resolved, you can look forward to having all the benefits provided in this new release.

We have taken measures to prevent similar incidents in the future. Thank you for your patience and understanding.

Team Zenarmor

58

Zenarmor (Sensei) / Introducing Zenarmor 1.13:

« on: May 05, 2023, 05:48:59 pm »

Introducing Zenarmor 1.13:
 
The greatly anticipated release of Zenarmor® 1.13 has just arrived and offers important new and improved capabilities that both technical and business decision-makers will find helpful when implementing security solutions to strengthen their overall enterprise cyber security posture.
A brief overview of the updates included in this release are:

• User PIN codes to bypass blocked content via the blocked content landing page
• Policy-based SafeSearch enforcement
• Scheduled advanced reporting through Zenconsole
• BrightCloud® Threat Intelligence Integration
• Enhanced RESTful API and improved API endpoints
• General bug fixes and performance improvements

So take a moment of your time, let's dive in and take a closer look at these new capabilities.
 
Click to Read The Article
https://www.sunnyvalley.io/blog#introducing-zenarmor-1.13-an-msp-and-enterprise-decision-makers-guide-to-how-these-new-and-improved-capabilities-can-enhance-overall-cyber-security
 

59

23.1 Legacy Series / Re: [CALL FOR TESTING] Netmap generic mode queue stall fixes

« on: April 27, 2023, 09:48:42 am »

Hi @dfw3xam1n3r
Did you test Zenarmor with Routed (L3 Mode, Reporting and Blocking available) with emulated netmap driver on OPNsense 23.1.6 and have any issues? Some users reported that their problems are resolved with this configuration.

60

Zenarmor (Sensei) / Re: Sensei throughput cap despite high-performance device

« on: April 26, 2023, 04:58:36 pm »

Hi jclendineng,
Did you try the latest OPNsense 23.1.6 and select the emulated netmap mode for Zenarmor deployment?
The latest kernel includes some netmap improvements.
Bests