Messages

1

General Discussion / Re: opnsens LAN can't use printer

« on: May 28, 2021, 08:02:48 am »

It looks like you are using 10.0.0.0/16, so your router has nothing to do with this connection problem; it should connect direct through the switch.

It appears you have one or more static IPs assigned because they are not sequential.  I would check these settings and subnet masks on both the printer and PC.  You can run an 'arp -a' command before/after a ping to see if the printer shows up.

my pc ip config，gateway not core switch iP， ping printer is ok
iP address ： 10.0.9.20/24
gateway ： 10.0.9.2

2

Virtual private networks / openvpn client export static ip for user

« on: May 28, 2021, 04:47:28 am »

Dear all,

below jpg is my "client export" config, i hope client get static ip, but it's not work, how can i do?
thanks.
 
this is client(windows 10) error message
2021-05-28 11:50:37 WARNING: Compression for receiving enabled. Compression has been used in the past to break encryption. Sent packets are not compressed unless "allow-compression yes" is also set.
Options error: option 'ifconfig-push' cannot be used in this context (Remote_Staff_otis.ovpn)
Use --help for more information.

3

General Discussion / Re: opnsens LAN can't use printer

« on: May 27, 2021, 05:12:49 am »

Hello all,

I use Wizard：GeneralSetup，and Network setup is complete .
But  i can't use printer . What else needs to be set ?
thanks.

4

General Discussion / opnsens LAN can't use printer

« on: May 27, 2021, 04:57:04 am »

Hello all,

I use Wizard：GeneralSetup，and Network setup is complete .
But  i can't use printer . What else needs to be set ?
thanks.

1.jpg
my printer stop screen. if firewall disable it work.

5

Virtual private networks / Re: Routed s2s question

« on: January 19, 2021, 04:51:06 am »

Thank you for your explanation, I set it up successfully

6

Virtual private networks / Routed s2s question

« on: January 18, 2021, 07:55:43 am »

Dear opnsense friends,

I Setup Routed IPsec site to site and my IPsec tunnel is up and running , Site A Lan connect my CoreSwitch and routing is add ok .
But i can't 10.0.1.0/24 to connect 192.168.99.2 (Site B FW) ,CoreSwitch ( route add 192.168.99.0/24 gw 10.0.9.2)is added. Ping or Tracert is Deny, Use Http no any message log , How do I set to allow 10.0.1.0/24 to pass site B Lan ?

Site A
wan 1.2.3.4
lan 10.0.9.2/24
Tunnel network 172.18.18.1

Site B
wan 4.3.2.1
lan 192.168.99.2/24
Tunnel network 172.18.18.2

  Live Log Message:
   LAN      Jan 15 11:04:21   10.0.1.23   192.168.99.2   icmp   Default deny rule   
   LAN      Jan 15 11:04:16   10.0.1.23   192.168.99.2   icmp   Default deny rule