1
Virtual private networks / Re: Specific Host through NordVPN
« on: December 18, 2020, 03:57:16 pm »
Looks like i got all this....some config from my fw below.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Virtual private networks / Specific Host through NordVPN
« on: December 18, 2020, 07:30:57 am »
Hi All!
I am really stuck on this topic. I tried everything i found, but couldn't figure out how to get this working.
I set up the NordVPN and got the interface working, i can see it pulls an IP. I followed this steps to set up firewall:
When i now enable the rule to route traffic via VPN, i cannot access web. i get a security error and cannot proceed to any webpage.
I also applied the DNS Servers as of NordVPN instructions:
And
To me as a newbie it looks like there is something wrong with the DNS. I am also running a DHCP server on OPNSense (IPv4). Can anyone help me?
I would like to only route a couple of hosts through VPN and not all. Anyone having a similar setup/issue?
My setup is this:
WAN -- Fritzbox -- OPNSense -- LAN
I am really stuck on this topic. I tried everything i found, but couldn't figure out how to get this working.
I set up the NordVPN and got the interface working, i can see it pulls an IP. I followed this steps to set up firewall:
Quote
https://forum.opnsense.org/index.php?topic=8998.0
When i now enable the rule to route traffic via VPN, i cannot access web. i get a security error and cannot proceed to any webpage.
I also applied the DNS Servers as of NordVPN instructions:
Quote
Navigate to System -> Settings -> General and do the following changes:
Under Networking, check the Prefer IPv4 over IPv6;
DNS servers:
103.86.96.100, Use Gateway: none;
103.86.99.100, Use Gateway: none.
On DNS server options, uncheck Allow DNS server list to be overridden by DHCP/PPP on WAN
And
Quote
Navigate to Services -> Unbound DNS -> General.
Enable: check;
Listen port: leave blank;
Network Interfaces: All;
DNSSEC: uncheck;
DHCP Registration: check;
DHCP Domain Override: leave blank;
DHCP Static Mappings: check;
IPv6 Link-local: unchecked;
TXT Comment Support: leave unchecked;
DNS Query Forwarding: check;
Local Zone Type: Transparent;
Custom options: leave blank;
Outgoing Network Interfaces: NordVPN (or whatever you named your OpenVPN interface);
WPAD Records: leave unchecked;
To me as a newbie it looks like there is something wrong with the DNS. I am also running a DHCP server on OPNSense (IPv4). Can anyone help me?
I would like to only route a couple of hosts through VPN and not all. Anyone having a similar setup/issue?
My setup is this:
WAN -- Fritzbox -- OPNSense -- LAN
Pages: [1]