Messages

Was able to figure this out. It was a configuration on my switches, not the router. Had all my switches configured to be on a management vlan. In this example that would have been VLAN2. Ended up having to toggle that management vlan to LAN, swap in the new opnsense router, then I was able to switch it back. At that point the proper static mappings were handed out.

Can anyone help out with this situation?

Created VLAN2 on the LAN interface, Setup DHCP for VLAN2, and added DHCP Static Mappings. DHCP leases update to the correct static mappings under leases, but not on the systems themselves. The obvious release/renew commands have been run on various systems with different operations systems, what am I missing? Are there additional firewall or NAT rules required to make this work? Any help would be appreciated.

I'm new to opnsense, but can someone please confirm if dchp static mapping for vlans is working in this version? I have no issues with this working on the LAN interface, but have cannot get this is working on any vlan. If I'm missing something basic, any help would be appreciated.

That worked, thanks!

I have the same issue on a ryzen embedded box. Did you figure out a way to complete this install?