1
15.1 Legacy Series / Bridge mode but FW wont work..
« on: May 12, 2015, 05:18:01 pm »
I have 2 nics on a OPNsense Vm, bridging my LAN to my ISP router.
I have both nics in a `bridge0` but if i enable the FW all my traffic stops.
Ive checked my interfaces are assigned to LAN/WAN correctly but i cant see why its not passing traffic as per the rules.
WAN interface doesnt have any rules.
LAN Interface has IPv4/ANY/ANY rule outbound.
im not quite clear on how the LAN/WAN rules are applied to the interfaces in bridge mode.
I see FW logs showing rule 3 blocking some traffic on `bridge0` , but the FW rules listed dont have numbers ... how do i match up which rule it is .. and i dont have any FW rules on `bridge0`.
confused.com
is there a guide or doc, on how to setup basic bridge-mode for my fairly simple setup ?
I have both nics in a `bridge0` but if i enable the FW all my traffic stops.
Ive checked my interfaces are assigned to LAN/WAN correctly but i cant see why its not passing traffic as per the rules.
WAN interface doesnt have any rules.
LAN Interface has IPv4/ANY/ANY rule outbound.
im not quite clear on how the LAN/WAN rules are applied to the interfaces in bridge mode.
I see FW logs showing rule 3 blocking some traffic on `bridge0` , but the FW rules listed dont have numbers ... how do i match up which rule it is .. and i dont have any FW rules on `bridge0`.
confused.com
is there a guide or doc, on how to setup basic bridge-mode for my fairly simple setup ?