151
20.1 Legacy Series / Re: Dual WAN - WAN2 should really be used only in case WAN1 is dead (WAN2 metered)
« on: April 20, 2020, 07:13:31 pm »
it will be be used to some extent... since opnsense will monitor your wan2.
in gateway you can disable monitoring for wan2(setting of wan2)
give your wan1 a higher priority (by giving a lower priority number, wan1 should be marked "active")
you may also opt for gateway group, in failover mode.
and used that group as your gateway in your firewall
i dont think pings can used alot of MB maybe it is activated?
try the above first, disable monitoring for wan 2(may have side effects though not being able to detect if it is online).
set failover group and use that... set proper link priority...
you may want to check, reporting then insigth, and verify the used data if it matches your sim2 data volumn.
you can drill down the data to specific wan, and length/days
in gateway you can disable monitoring for wan2(setting of wan2)
give your wan1 a higher priority (by giving a lower priority number, wan1 should be marked "active")
you may also opt for gateway group, in failover mode.
and used that group as your gateway in your firewall
i dont think pings can used alot of MB maybe it is activated?
try the above first, disable monitoring for wan 2(may have side effects though not being able to detect if it is online).
set failover group and use that... set proper link priority...
you may want to check, reporting then insigth, and verify the used data if it matches your sim2 data volumn.
you can drill down the data to specific wan, and length/days