61
General Discussion / Remove Double-Nat help needed
« on: March 28, 2019, 10:38:02 am »
Hi,
I have opnsense configured on a 10.x.x.x range for all my wired devices
I have Google Wifi installed in router mode to make use of the mesh network (as some of the units are in areas that can't be hardwired back) - the google wifi gets it's ip on the wan for 10.x.x.x range and then allocates the range 192.x.x.x to its clients.
Is there a way of enabling the google wifi to provide addresses within the same range as the wired devices
And is there a way of getting IPv6 addressing through to the Google Wifi so it can allocate IPv6
I have a static ipv6 setup and isp provided range /64 (wan) and /48 (local) - my wired devices are receiving their ipv6 details, but would like to get this on the wifi devices as well
I have opnsense configured on a 10.x.x.x range for all my wired devices
I have Google Wifi installed in router mode to make use of the mesh network (as some of the units are in areas that can't be hardwired back) - the google wifi gets it's ip on the wan for 10.x.x.x range and then allocates the range 192.x.x.x to its clients.
Is there a way of enabling the google wifi to provide addresses within the same range as the wired devices
And is there a way of getting IPv6 addressing through to the Google Wifi so it can allocate IPv6
I have a static ipv6 setup and isp provided range /64 (wan) and /48 (local) - my wired devices are receiving their ipv6 details, but would like to get this on the wifi devices as well